All of the plastic parts to build the V1 Drivetrain. All parts are within 0.10mm of specification. They are printed in PLA, 5 walls, 5 top, 5 bottom, 35% infill. Depending on the part, layer height is from 0.20mm to 0.10mm. Parts are printed with supports and helper disks where needed, they are shipped with these still in place.
Please allow approximately 30 days from order until shipping, these are made to order. Part color is dependent on availability, this may be white, gray, black, or a mixture...I will try to keep all of the parts the same color in a single kit. If there is a special color request, please contact me PRIOR to ordering, as this may change time/cost.
Please specify the type of frame you will be using.